![]() ![]() Step 8) Enter your password, confirm password, then click “Apply”. Step 7) Choose from one of the below options and fill out the “Switch Ports” section accordingly:ġ) Devices on eth1 to eth4 will receive an IP address from Mesh Node A on eth0.Ģ) The EdgeRouter X will receive an IP address from Mesh Node A to access configuration settings.ġ) Devices will receive an IP address from Mesh Node B on eth1.Ģ) The EdgeRouter X will receive an IP address from Mesh Node B to access configuration settings.ġ) Devices will receive an IP address from Mesh Node C on eth2.Ģ) The EdgeRouter X will receive an IP address from Mesh Node C to access configuration settings.ġ) Devices will receive an IP address from Mesh Node A on eth1.ġ) Devices will receive an IP address from Mesh Node B on eth2. Step 6) Select “Switch” in the left column, then:Ī) check the box “Use non-default VLAN for management”Ĭ) check “Enabled” in the “VLAN Aware” section ![]() Step 5) The User Interface prompts to use the Setup Wizard. #EDGEROUTER X PORT FORWARDING WIZARD PASSWORD#Login with default user = “ubnt” and password = “ubnt”. Be very patient, it can take up to 3 minutes after power is applied to (or a reboot of) the EdgeRouter before responding. Step 3) Plug network cable between laptop and EdgeRouter X “eth0” port. Step 2) Setup laptop with static address: If unsure of the EdgeRouter’s state, press and hold the reset button until the “eth4” light cycles through: blinking, solid, off. Step 1) The EdgeRouter is assumed to be at factory default state. You can get this switch from Amazon by clicking this link Ubiquiti Edgerouter X - Router - Desktop - Black (ER-X) Follow the 13 steps below to configure a Ubiquiti EdgeRouter X. Configuring an EdgeRouter X for use with AREDN networks ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |